rkible
08-24-2007, 04:25 PM
Thanks in advance to any help.
When booting up on my second boot after my computer build, I now get a screen that says "reboot & select proper boot device or insert boot media in selected boot device & press a key". If I clear the CMOS as instructed when there are some types of problems ,it boots up fine & shows system info & hard drive installed. Everything looks fine until I exit & then on next boot it will show the "reboot" message again. The Bios configurations shown on the my super pc website are totaly different than the screens Iam getting so I cannot select the settings instructed. Am I ok to install the OS now which is the next step, or do I need to make some changes? As I said when I boot after clearing the CMOS it does show the RAM, Processor, hard drive, DVD/CD drive & floppy drive. Everything is recognized. Any help is appreciated
thanks
rkible
When booting up on my second boot after my computer build, I now get a screen that says "reboot & select proper boot device or insert boot media in selected boot device & press a key". If I clear the CMOS as instructed when there are some types of problems ,it boots up fine & shows system info & hard drive installed. Everything looks fine until I exit & then on next boot it will show the "reboot" message again. The Bios configurations shown on the my super pc website are totaly different than the screens Iam getting so I cannot select the settings instructed. Am I ok to install the OS now which is the next step, or do I need to make some changes? As I said when I boot after clearing the CMOS it does show the RAM, Processor, hard drive, DVD/CD drive & floppy drive. Everything is recognized. Any help is appreciated
thanks
rkible