1st Boot problem

[rkible]

the 1st boot did everything it was supposed to except it did not reach the final screen that you show. It loaded the defaults & I saved & exited. Then it went back to the screen showing the amount of memory, processor speed etc. I got the 1 beep indicating no problems but no final screen that you show. At the very bottom of the screen it said "Drive A Error" & below that it said press F1 to continue. Am I ok since I got the 1 beep? Fans are all working also. HELP.
rkible

[The Wise Monkey]

Drive A is the floppy drive, so try booting without the floppy connected.

[rkible]

Thank you for your response. I dont have a drive in yet, this is my 1st boot
after installing the processor, fans, & memory. Iam following the procedure that is shown on the "my super PC" website. Any feedback is greatly appreciated.
thank you
rkible

[Rob]

Probably what you're seeing is ok for a first boot configuration.

[rkible]

Thanks Rob, that makes me feel a whole lot better. Not knowing for sure is kind of a bummer. Your website is great, it has really helped. When Iam finished I will let you know how it went. This is my 1st build & I am having a
lot of fun. Thank you for all your help. I am planning on sending a tip also.
thanks again!
rkible