mrfran
08-14-2008, 08:17 PM
hi so i hooked up everythng on my computer, everything seems working (mobo lights on green, all components running, fans are running too) no beeps
and im getting the NO SIGNAL error
i have:
p5q pro
bfg 9800gtx+ OC
corsair dominator (2x2gb)
antec 900
(and all the other parts not involved?)
k so what w did was...
1. reset CMOS, took the battery out waited couple of mins and put back in
2. switched RAM around
3. took off video card(no beeps) took off ram ( no beeps too)
4. replaced monitor DVI cord to Analog cord even used converter
5. took off connections on mobo one at a time
UPDATE: disregard got if figured out now after 6 hours of tinkering, seems that the mobo just needs an extra power cord
_________________________________
K so i got everything running fine but now i keep getting BSOD whenever window update runs.... also the 6 engine EPU thingy for p5q pro says it cant detect my VGA i checked my system info and its there tho
disregard this post all are working properly now
and im getting the NO SIGNAL error
i have:
p5q pro
bfg 9800gtx+ OC
corsair dominator (2x2gb)
antec 900
(and all the other parts not involved?)
k so what w did was...
1. reset CMOS, took the battery out waited couple of mins and put back in
2. switched RAM around
3. took off video card(no beeps) took off ram ( no beeps too)
4. replaced monitor DVI cord to Analog cord even used converter
5. took off connections on mobo one at a time
UPDATE: disregard got if figured out now after 6 hours of tinkering, seems that the mobo just needs an extra power cord
_________________________________
K so i got everything running fine but now i keep getting BSOD whenever window update runs.... also the 6 engine EPU thingy for p5q pro says it cant detect my VGA i checked my system info and its there tho
disregard this post all are working properly now