Barrister73
02-01-2008, 05:44 PM
From reading the ASUS website, it looks like the P5KC needs the BIOS updated before it is compatible with the E8400. I consider this to be a fatal flaw in a design, but I'm not a computer engineer and do not know the intricacies of designing a board, so I won't harp too much.
If that is the case, then BobaFettK and I would need a low-end processor to get the computer started so we can get the correct BIOS and then install our actual CPUs. None of the computer service places near me have a decent website (again: fatal flaw) so I cannot tell what it would cost for them to install an older CPU for a few minutes and update my BIOS, or if they even would. I imagine that once I am done making calls tomorrow, I will decide to just do it on my own. Which begs the question to Jamie, or whomever;
What cheap CPU should I get to do this install (or, who has an old 775 Pentium I can rent)?
Thanks
MRR
--------------------------------------------------------------------------
Ignore the above. Due to further research and BobaFettK's statements, what was said and asked is no longer relevant. I choose to not delete it because that would cause the thread to not make sense.
If that is the case, then BobaFettK and I would need a low-end processor to get the computer started so we can get the correct BIOS and then install our actual CPUs. None of the computer service places near me have a decent website (again: fatal flaw) so I cannot tell what it would cost for them to install an older CPU for a few minutes and update my BIOS, or if they even would. I imagine that once I am done making calls tomorrow, I will decide to just do it on my own. Which begs the question to Jamie, or whomever;
What cheap CPU should I get to do this install (or, who has an old 775 Pentium I can rent)?
Thanks
MRR
--------------------------------------------------------------------------
Ignore the above. Due to further research and BobaFettK's statements, what was said and asked is no longer relevant. I choose to not delete it because that would cause the thread to not make sense.