Barrister73
01-29-2008, 08:52 PM
Specs:
CPU: Intel Wolfdale E8400 3.0 gHz processor
mobo: Asus P5KC
RAM: CORSAIR 2GB(2 x 1GB) 240-Pin DDR2 xms2
PSU: Corsair HX520w
GPU: evga 7900 GS KO 256MB
hd: Western Digital Caviar 320
Optical: Not installed
case: Antec 900
Floppy drive: Not installed
I am having the same problems as BobaFettK. Every fan works, all the fan LEDs light up, GPU fan works (GPU works on other computer). No VGA detected.
I tried all combinations with the RAM. Because the ram says it is 2.10V, I tried some older ram from my other computer. Still no VGA. I swapped in my oldest ram (2x 256) and noticed that the reset button worked in that configuration, or 1x 256, but not with any of the other RAM.
Also, the LED on my wired keyboard lights when I first turn on power, but never again. It would normally be on whenever there is power.
Because neither the case nor Mobo have a speaker, I cannot hear the warnig beeps. I also cannot seem to find any place that sells just a system warning speaker to hook up.
As far as I can tell, everything is hooked up. 24 pin, 4 pin, all fans plugged into the PSU, CPU fan, HD (just to see if there was any change). Chassis Signal is grounded, CLRTC is on 1+2. I even removed the battery for 45 minutes to make sure everything was reset.
Any other thoughts? I really do not want to RMA this thing.
Thanks
MRR
CPU: Intel Wolfdale E8400 3.0 gHz processor
mobo: Asus P5KC
RAM: CORSAIR 2GB(2 x 1GB) 240-Pin DDR2 xms2
PSU: Corsair HX520w
GPU: evga 7900 GS KO 256MB
hd: Western Digital Caviar 320
Optical: Not installed
case: Antec 900
Floppy drive: Not installed
I am having the same problems as BobaFettK. Every fan works, all the fan LEDs light up, GPU fan works (GPU works on other computer). No VGA detected.
I tried all combinations with the RAM. Because the ram says it is 2.10V, I tried some older ram from my other computer. Still no VGA. I swapped in my oldest ram (2x 256) and noticed that the reset button worked in that configuration, or 1x 256, but not with any of the other RAM.
Also, the LED on my wired keyboard lights when I first turn on power, but never again. It would normally be on whenever there is power.
Because neither the case nor Mobo have a speaker, I cannot hear the warnig beeps. I also cannot seem to find any place that sells just a system warning speaker to hook up.
As far as I can tell, everything is hooked up. 24 pin, 4 pin, all fans plugged into the PSU, CPU fan, HD (just to see if there was any change). Chassis Signal is grounded, CLRTC is on 1+2. I even removed the battery for 45 minutes to make sure everything was reset.
Any other thoughts? I really do not want to RMA this thing.
Thanks
MRR